Maintenance and Care of Bearings in Organic Fertilizer Crushers: For organic fertilizer crushers, the bearings bear the entire load of the equipment. Therefore, their quality and lubrication condition directly affect the service life of the bearings, which in turn impacts the lifespan of the organic fertilizer crusher. This should be taken seriously. Here, the organic fertilizer crusher manufacturer reminds everyone.

     1. In terms of lubricant usage, the primary requirement is that the lubricant employed must be clean and of good quality. If the quality is substandard or contains impurities, it must not be used under any circumstances.

     The lubrication parts on the crusher bearings, in general terms, include rotating bearings, roller bearings, sliding bearings, gears, and sliding planes, all of which are indispensable.

     3. Before trial operation, conduct a thorough inspection of the equipments installation in all directions to ensure compliance with regulations, check for loose screws and bolts, and test the belt by gently pulling it to verify if there are any shell contact issues. Additionally, inspect the rotation direction, prevent the crushing of flammable or explosive materials to avoid accidents.

     4. During production, uniform material cutting should be maintained to ensure crushing quality and normal production. Additionally, motor overload must be prevented to guarantee the proper operation of the branch shredder.

     5. In addition to regularly checking for loosening or tightening in all directions, special attention should also be paid to inspecting the damage of components. If severe damage is found, replacement should be carried out immediately to prevent damage to critical parts. Appropriate fire prevention measures should also be implemented.

     6. Due to the high rotational speed, in addition to proper and secure installation, consistent lubrication should be maintained to ensure the normal operation of the wood chipper. Under normal conditions, the bearing temperature should not exceed 70 degrees Celsius. The main bearing should be greased once a week, with high-speed grease providing better results.